Knifeless Tape is a handy tool used to make precise cuts in films such as vinyl wrap.
It is designed to help create straight lines, curves and shapes without the risk of scratching or damaging the surface the film is applied to. Here are some steps to use Knifeless Tape:
-
Measure and mark the place where you want to make the cut. Then place the Knifeless Tape on the mark with the wire along the line you want to cut.
-
Gently pull the thread of the Knifeless Tape, while holding it with your other hand. Make sure the thread is tight and straight along the line you want to cut.
-
Once the wire is in the desired position, gently press down on the tape to hold it firmly in place.
-
Now use a tool to cut the foil, such as a plastic knife or a pair of scissors. You do not need to cut the foil where the Knifeless Tape runs, because the thread of the tape will cut the foil as you guide the knife or scissors along the tape.
-
Finally, carefully peel the Knifeless Tape off the foil. The thread of the tape will cut the foil where you guided the knife or scissors.
Always use the Knifeless Tape carefully and precisely to make accurate cuts and avoid damaging the surface.
